had to put three skarf joints in it, the last one only 150mm. the foam is white polystyren coated in resin. the three shapes one is the original plans no rocker and this shape is not recomended. the ones drawn up by Phill Pearce are based on the Lane hulls built in south australia from about 1991. the other one was drawn up by Ken Lott in about 1985 both drawings have a lot of rocker and verry little seperats these two drawings. at this stage one hull is ready for decks, and the other will be going into the deck jig this week. the frames havent distorted the shape at all, the only place that is out of shape is where i have a skarf joint in the cedar, i dont think it will be to visable when the decks are on, as it dosent look the best.
