TMS-20 out of mold

This is the last post for a while. I put three temp bulkheads in the hull half and hung it by the bulkheads. The next step on this piece is to bog the outside with West System epoxy mixed with 407 and then fare the outside with a long board. Then flip the stations in the mold and start on the other side. Here are some pictures of the hull half hung on the cutting table. The last picture shows a tapeline where the ama will be.

Much Later….. After my shoulder works again.

Mike

More...

More...

very nice mike

while your shoulder is buggered feel free to tell us 5.2 owners what you did to your nacra

Hi Mike,

Hope your surgery went ok. Post a note to let us know how it went.

speedy recovery!!!

Thanks Guys

Hurting like I got hit by a train. They have me on some strong pain pills. Still hurts and can’t get comfortable or sleep more then an hour or two at a time. One of those things where each day you get a little better.

I was in an anesthetics fog post-op what I heard was they went in with a scope then ended up cutting me for the repair.

Hanging in there!

One day soon you will wake up and say "hay it doesn't hurt anymore"

Good luck.

Hang in there and do you Physical therapy. Carbon won't rot so there's no hurry.
Have a rum drink, it'll help.
Todd