On my wooden mossie, I made sure the holes would go through the stringer. Also I cut some short stainless tube and expoxied them into the holes. The tube is just big enough to take 2 mm Dyneema and I place a large washer on the outside to spread the strain. I tie a loop on the inside near the bow and then tie from the spinnaker pole to the loop. That way I can untie it and even untie the loop to completely remove everything. Without the stainless tube it started to chafe the hole bigger. It came undone once when I didn't tie a proper knot. 2 mm Dyneema strong enough up to 20 knots so far!