I want to here some ideas on what you guys think is the best way to measure toe-in on a canted rudder boat (Infusion, Capricorn, etc). On canted rudders if you measure the leading edge then move to the trailing edge your measurement can vary ALOT just based on moving an inch up or down on the rudder.

My best guess: Drop the boat in the water on a calm day and mark the waterline on the leading and trailing edge. And use these two points to take your measurment......Does this sound good to you guys?

PS...This is not meant to be a discusion about how much or how little to toe-in my rudders. Just wanting to hear some ideas for finidng the right location in regards to leading edge and trailing edge measurement locations on canted rudders!