Karl,
It's just a new delivery system(thickened unmixed West in a caulk tube). I used West system and fiberglass fibers to seat my beams. Just make sure you use a good mold release on your beams to pop them back out or you'll have the problems Mike is referring to. I was just thinking it would be easier than me screwing up a ratio when mixing. I also thought that covering the bottom of the beam in vinyl like the graphics guys use would be an easy way to get things to pop apart later on. Then again it might not work. Get the pumps that ratio the West system. They're cheap like $10 or $12. Makes it alot harder to screw up.One pump of resin equals 5parts to one pump of hardener which equals 1part.Then mix in your thickener of choice. No problem.
"I said, now, I said ,pay attention boy!"
The cure for anything is salt water - sweat, tears, or the sea
Isak Dinesen
If a man is to be obsessed by something.... I suppose a boat is as good as anything... perhaps a bit better than most.
E. B. White
| 
