Sorry for the confusion. I'll try to get pictures this evening. Please allow me to try explain. On the front cross bar is a pin sticking out, that the short C/B pole slides onto. As Philip stated it is a two piece pole. the longer pole then slides over the 4-5 inches of the shorter pole. The loop then slides into the end of the longer pole. When I was tightening the bridle wires to the loop, I put to much bend in th epole, (downwards pull and broke the longer pole, where it slides onto the shorter one. It splintered in two places where it slides over the shorter pole. So my question is, can you just re-resin the cracks in the longer pole and place material around the outside to strenghten it. Also would it hurt to just resin the longer onto the shorter permanently?
Thanks
Forrest