See the manual above, or send Chris an email about it, he set ours up. Basically:
in from port side over through fixed block on stb side
back to port side, through a moving block, then out the stb side
the moving block is attached to a bungie, the bungie runs through port side fixed block and dead ends on stb (I think, might run back... can't remember).
We also ran ours out to the crew's trap set, ensured I can reach it, as well as skipper when needed.
Nice thing about continuos, if the crew forgets to cleat the leeward side, the can actually pull all the slack out of the beam and cleat it.
If that makes no sense, I can try and draw a picture.
Last edited by maritimesailor; 11/03/10 09:03 AM.