Close up of the Prindle wing.

You can see where he had to move the bolt a little to get the wings to fit. They were held in with pins on the front of the beams and just slid into the beams through the end caps. That made a serious pressure point where they sat in the hole of the end caps!

The diameter of the Performance wings was a little smaller, so I didn't have to move the bolts on my 18-2.

Attached Files
wing close.JPG (207 downloads)
Last edited by Dan Berger; 12/22/10 10:22 AM.

Dan Berger
Norfolk, VA
A Cat USA139
Supercat 15