Ok so with everyones help i finally figured out the rigging. Now i need to figure out how the boom is rigged. I have a traveler on the top with a cheek block on the back, a cleat half way down on the side with an eye loop right above it, and a cleat near the mast on the top with a hanger right in front of it. There is a bungi on the car going forward to an eye loop. It looks like it is soppose to put pressure so the car returns forward for downwind sailing? Also, where do the double trap wires run to? Do they run under the tramp or through the crossbars? I also notices in the above picture that there is a small block on the side of the hull. Is this for a spinnaker? And then is the main traveler setup just like a newer h16 where the main sheet controls the traveler as well? Thankyou so much again all!! ~Reid