Hi folks I need help ! Im adding a furling system and jib to my newly restored Hobie 14 but ran into a problem. First thing is I did not use a stock Hobie furling drum and swivel that the bridle wire attach above the drum, but I opt for a Harken small boat furling system that the bridles will connect below the drum. Well heres my problem how do you set up a fore stay adjuster with multiple holes to adjust mast rake on this type of drum. The Harken drum has a jaw type fitting on top and bottom of the drum I assume the luff wire goes in the top jaw of the drum with a clevis pin and ring ding but the bottom end needs a toggle with adjusting holes to rake the mast . On the factory Hobie drum it looks like the toogle slides right through the center of the drum to adjust rake but I cant do that on this set up. Im sure some one has seen this set up and can give me some help Thanks