So, the dock looked good, but there were 20k winds pushing the bow into it and BLAM BLAM... turns out there was a hidden bolt (I should know better).
I know there have been multiple posts on glass repair, but wanted some opinions (mainly on how to do the gel coat part of it or at least make it white). This picture is after dremeling out the crushed fiberglass (as you can tell, it is through the hull completely and I had to take the gelcoat off below due to it being cracked). I figure I would use West System epoxy with silica to thicken it and put that in first then just use a boat load of epoxy and sand it down to level. But how to make it white?
ps sorry about the poor image- don't have my card reader and this is from my cell phone.

Attached Files
61693-hole.jpg (475 downloads)
Last edited by PTP; 11/18/05 02:08 PM.