(NB: the unit behind my rolling die is off a Taipan and is what I'm duplicating, only slightly smaller )
all the bits are now rolled and ready for assembly which I'll do if I find a spare minute or 10 over the next few days. Haven't decided on whether I'll tig weld them together or just use pop-rivets and small bolts as yet, but the plan does call for some stainless steel plates to be pop-riveted on, these plates will strengthen up the areas around the hinge pins etc and reduce wear down to a minimal amount...
merry xmas to all
Yar, & this ere post be done without a sin'le drop o' rum passin' me lips
Kingy started with Impara Cadet #3 / Mosquito #245 & now Mosquitos #1182 & #1740