I was just looking at the pictures, and feel the need to add a little more information. On the 2nd system listed in my previous post, I had trouble with my sheet getting tangled in the original swivel cleats that are used for the traveler control. I removed these cleats and put a couple ronstan cleats on the corner casting.



The picture of the 01-3112 system shows these cleats mounted on the cross-bar. I initially mounted mine there, and found that they were to low, so I positioned them on the courner casting, and mounted my cheek block approximately where it is on the picture but with a slight angle to ensure the line ran straight through the cleat.



David