Thanks Jack, but i dont think it would fit. The corner castings for the tramp are made to fit to a hobie 14 mast which is smaller than the Hobie 16. There are lots of ways it could be modified to fit but they would all require extensive fabrication. I have gotten suggestions from making one out of wood, fibreglass, carbon fibre, stainless steel etc.

I spoke to the hobie company and they believe that it is not possible to replace them, after trying to remove the remains of the old ones i was inclined to agree but when my new pylons have been fabricated i intend to just glass them back into the hull.

It probably isnt going to be pretty.

Thanks for the offer...

Ben