Originally Posted by Dan_Delave
I use Robline spliced to 1/4 Vectran. I like it alot. I put holes in the sides of each then run the other through so it will be in a locked position (similar to how a figure eight locks). Then I push the tails into the opposite side to hide them. You will need to shave the Robline into a taper before stuffing. The Vectran goes in okay.

Thanks Dan.. sounds like what i want to do. i am not sure i understand the method "I put holes in the sides of each then run the other through so it will be in a locked position". can you eleaborate or do you have a picture?

thanks