Karl and other uni-trappin-spin flying peeps -

I saw a picture (cannot find it now) of a single handed set up that had a 57mm Harken block with 8 inches of dynemma tether to the rear beam (below the tramp and came out through a grommet on the tramp). The spin sheet went through this block on its way around the boat (obviously the two bitter ends were tied to the spin clew on each side).

The idea was to have the sheeting angle be more perpindicular to the hull rather than pulling you forward along the hull. Would that set up make trapezing with spin up easier? Is it worth it?

It seems as though it would make a huge difference.....