This is the last post for a while. I put three temp bulkheads in the hull half and hung it by the bulkheads. The next step on this piece is to bog the outside with West System epoxy mixed with 407 and then fare the outside with a long board. Then flip the stations in the mold and start on the other side. Here are some pictures of the hull half hung on the cutting table. The last picture shows a tapeline where the ama will be.
Much Later….. After my shoulder works again.
Mike
Mike Shappell www.themanshed.com TMS-20 Builder G-Cat 5.7 - Current Boat NACRA 5.2 - early 70's