I have a question about the setup of the barberhaulers on a 16. I suspect that mine may be rigged improperly because there is a rubbing of the sheet over the block when drawn tight. From the outside towards the center of the boat mine is set up as follows hole
1 outhaul adjustment hole
2 block for the jib sheet
3 end of jib sheet
4 shock cord


So looking towards the bow from the tramp the two look as follows:

1234 4321

Is this right? Do others have it rigged in a different fashion?

Thanks


The SLO_Boozer H 16 - "First Wish"