sorry, for the thread resurrection, but this is the best thread that references the 5.8 to 5.8na conversion.i know i need the following parts; complete bridle foil assemblies, forestay, and new jib. my question is about this post.
If you decide to add the bridal foil you will need to add sleeves to the inside of the front crossbar. Performance sells them for about $20 each. Check out
www.thebeachcats.com and post that you are looking for a set of used 5.8 sails also check ebay. I have seen them on these sites before.
what are these crossbar sleeves?
Thanks,
G~
Having had one of the earliest 6.0na's, then retrofitting a spin and DIY snuffer to it-
I'd take Lee's and other advice and go with a spin. set up and forget about the foil, et. al.
Actually, the original ones with the forward beam mounted jibs would be even better- doubt any still around though.
Research the spin hound on top, and use the rotating kind of hound, not a fixed point- better for the mast also.
