I used a different sheet of fabric on each side. Do one side at a time and spend the time squeegee - ing out all the bubbles and excess resin. Let the fabric hang over the edge. Use some nylon peel ply on top of the fabric to help smooth out the fabric and absorb any excess resin. That way you get a nice smooth surface once you peel off the peel ply. Wait at least overnight before peeling off the peel ply, then trim the edges with a sharp knife and clean up the edges with a light sanding sanding with 100 grit.

Hit the whole thing with a light sand of 100 to get out the major bumps followed by a even sanding of 220 wetsand. Use a block and hand sand it so you dont go thru the fabric.

Cover it with a clear 2 part poly, I used System Three WRU-LP. Go light on the coats and use more coats vs less thick coats. Sand this out (320-1500) for a mirror finish. If you are going to wet sand the final finish, put on at least 4 coats and wait 2 weeks for the finish to finish curing and harden up.