Hi folks, Looking to buy a seven year old Wave. Wondering if their are any concerns I should be aware of? Their are some shallow gouges on side of hull, black scuff marks probably from rollers, and normal fading. Biggest question I see, there is what appears to be a sleeve over the rear crossbar that is supposed to be in the hull, but is sliding out a little. I see a couple of inches sticking out?? Any advise is appreciated. Thanks
Not sure about the problem you are point out about the beam. I know my son's Wave was out of square, so he put some stoppers on the beam after measuring front and back to be sure they were the same across. Rick
A sleave sticking out a few inches? That would be an odd one. You have sheared off its hardware designed to mold it as part of the hull. Is that a problem? Maybe. Maybe not if its the rear and you can slide / pound it back in place and it doesn't leak.
I measured my Wave and found there was about a 3/4" difference in the measurement between the bows and sterns, the Bow measurement was less. What kind of "stoppers" did your son use and how did he fasten them on?
I made some "shims" that fit between the stopper on the forward cross member and the hulls, and tried some double sided tap to hold them in. It didn't matter if I fastened them to the hull or the stopper, they always shifted, so I removed them.