Hey, I have all of the equipment for a kite kit for 5.2 but i have yet to put it together. My hold up has been the furthest rigging towards the bow... the way i see it done mainly is by drilling through the hulls and trying to reinforce that with resin. I was wondering if anyone had any less labor intensive ideas, maybe attaching hardware to the hulls?
any ideas would be great, thanks!!
-- Have You Seen This? --
Re: Ideas for adding Kite to NACRA 5.2????
[Re: Seabass]
#217730 08/17/1001:59 PM08/17/1001:59 PM
That's probably the cleanest...but drill through the bows, glue in a piece of fiberglass or carbon tubing, and trim it/sand it to perfection is easier.
Jake Kohl
Re: Ideas for adding Kite to NACRA 5.2????
[Re: Jake]
#217731 08/17/1002:17 PM08/17/1002:17 PM
I don't have holes in my bows I have dyneema line running from my bridal tangs to the end of the pole and another dyneema line running from the bridal tang straight across the boat to the other tang attaching to the pole in the middle. Just do the two shackles up at the bridal tangs then tighten the line under the jib bridal until your happy with the bend.
Jeff Southall Current boats Nacra 5.8 1703 Animal Scanning Services Nacra 5.8 1667 Ram Raider Nacra 18 Square Arrow 1576
Re: Ideas for adding Kite to NACRA 5.2????
[Re: JeffS]
#217761 08/17/1011:26 PM08/17/1011:26 PM
I drilled the bow's on my 5.2. The lines going back to the bridal mounts worked but it felt alot more secure with the bow lines in. I ran a F17 kite and endpole set-up and it worked great.