Tok my "new" cat out this weekend for a beach launch for the first time. Launch area was great, one to two foot surf. However, the cat got a bit sideways during one launch, and well, I'm sure you can guess. There was a loud creek/groan before I could straighten her out.



After finishing the day, I notice several small stress lines on the top of each hull. There was absolutely zero water leakage during the day (pulled the drain plugs and raised boat to 45+ degrees) and we had four people on board at times.



Are these lines something I need to address immediately? Is this a fiberglass job or something simpler?



Thanks for the help.



John.