Hi all,
I read the 2008 thread about spin sheets I think started by Karl.

Jumping ahead to my question,
I'm usin a spin sheet, with a short pigtail spliced into the middle of it- and the pigtail goes to the spin clew via a small bowline.

This method makes two ends of the spin sheet on the tramp after feeding thru the spin blocks on port and starboard.

This is the system I'm using for the sheeting system on my kite.

For those that have the ends run back like this, what do you do with them?
At first- I was taping them end to end so it would go thru a large block near the back of the tramp.

MOre recently, I'm tying each end to a bungee the runs in front of my rear crossbar at the back, from beam to beam.
This has worked OK also.

YOur systems on this?

TIA