Test fitting the mast upright support and figuring out where to cut it. My welding is getting considerably better thanks to some useful advice from a friend. I was a little nervous about this weld since a weld failure on the mast upright weld would be pretty dramatic at 80mph. There's an angled brace and another u-bolt not shown in the last picture yet. The coupling brace thing on the bottom of the tongue is smashed and got in the way of that last u-bolt until I cut it off later.


20160221_171752 by Jake Kohl, on Flickr


20160221_153144 by Jake Kohl, on Flickr


20160221_163535 by Jake Kohl, on Flickr