The jib blocks I got with the boat do not have any beckets and they were attached where you say they should be, the cables were bad and I wanted to sail her, so i moved the blocks until I get this set up the way it should be. It appears that in the pic you attached that there are lines off the back of the jib blocks that run for about a foot, but I can't see where they go to from there.

Are the cables which support the jib blocks supposed to be hard fastened (wire clamped) to the ones that run from the front beam to the back beam? Or is it supposed to be free to move?

You are correct the manual I am using is for several boats, and the deluxe may not have been an option for my boat.

I thought the standard setup had the adjustable rails on the hull, and I do not have that. I have what is pictured in your attachment, so I thought I must have the 4-way.

Thanks for the feedback...

Jeff