Thanks Rolf
I see a few similarities, but also quite a few differences...what I want to do is much closer to what was done on the LR2 & LR3
1) Make up the hull in "naked" foam first in a female open frame wood jig.
2) Glass the inner skin while nested in female jig.
3) Join both left and right halves (they did top and bottom)
4) Glass the outer skin.
5) Fair and finish.

In essence I want to use a very similar method to John Lindahl but without cutting a couple hundred strips and routing the edges of them if possible. After visiting the “Kelsall Swiftbuild System” website it seems their build system is quite different in approach to both John’s method and what to what I am proposing.