Florin
My table saw is 12" with a 64 tooth carbide tip blade...it's a beast...your trying to pry my wallet open again to buy a plywood blade with little "set"LOL...12" blades are not the $6- $10 a pop price of a 8" circular saw blade.

I have cut plenty of divinicell (up to 1-1/2" H130) with carbide tooth blades without problem but would be a little concerned about a saw blade with too little set...the slightest pause in forward progression thru the saw might melt the foams surface...as it has a fairly low heat distortion temperature.
3/8" = 9.52mm

John
Thanks for the info on strip width...I have been following you on the Yahoo LR2ACAT group for quite a while...I combed thru all your build information there, but didn't pick up the 1/16" gap criteria. Excellent piece of information.

Regards,
Bob