Id rather just see a minimum beach weight as its quite hard to get a panel weight without cutting cores from the boat. I think we need to look at least 55-60 kg to make sure we end up with a durable boat, and to also allow the rotomolded crowd an even shot at producing a competitive boat as well.

Also, the sail area measurement needs to differentiate between conventional rigs and pocket luff rigs, not quite fair to add the mast area to their sail area calc. I'll knock out a sail measurement spreadsheet that will take care of this.

In the interest of getting as much racing as possible for the kids, perhaps we might look at the existing designs out there to make sure the rule is as inclusive as possible of what already exists.

Under daggerboards and rudders, skegs should also be allowed as some existing designs have these.

Other than that....great start
RG