Hi Scarecrow,


Questions:
7. Uni strips with carbon? How much would you guesstimate is enough for a 1995x21x180mm board?

8. Fairing. How much work is this and how precise is the result? How critical is the trueness to the designed profile?

9. Is this laminate only to make the foil durable so a 120 to 220gsm glass cloth is enough?


In your opinion:

How critical is accuracy to the designed profile. Is a tolerance of 1mm, 0,1mm or even 0,01mm the target?

What about geometry of the foil. Any tapers complicate work. Same with rounding off the tip etc. Yet this is often not discussed even if it is "standard" to aim for an elliptical pressure distribution and to avoid drag from tips.


Thanks for your insights, much appreciated!