remember 1 thing please..... I've NEVER done this sort of thing before .... so be kind
I used air-drying clay as the lower part of the mould and once I had the desired height set I simply applied the PVA release agent to the rudder and clay base...... and a good smear on the workbench too just incase
Once I had the mould set it was time to duplicate the other side....
Released off of the table and now the fight to release the rudder from the mould begins...
fight over
Yar, & this ere post be done without a sin'le drop o' rum passin' me lips
Kingy started with Impara Cadet #3 / Mosquito #245 & now Mosquitos #1182 & #1740