Time to get rid of the mould frames.
I used 2 x2inch webbing straps.
The black one on the trailer winches in the middle of the hull took nearly all he load. The orange one up front allowed the hull to slide over it as it rolled.
[Linked Image]


Mark came round to give me a hand. He is in the pic below.
This is the guy that machined the folding mech on the back wall, mould frames and the rudder plug. It's good to know people who take real pride in what they do.
[Linked Image]

Once upright the air powered in line sander is a must.
It takes off any flairing towards the edges of the foam to make a really fair surface.

[Linked Image]

Attached Files
lifting the hull.jpg (1007 downloads)
lift and roll.jpg (1029 downloads)
in line sander.jpg (1038 downloads)
Last edited by phill; 02/18/14 02:36 AM.

I know that the voices in my head aint real,
but they have some pretty good ideas.
There is no such thing as a quick fix and I've never had free lunch!